Scopus (CiteScore 2022 =3.0, Q3) , ISC

Document Type : Original Research Article

Authors

Department of Prosthodontics, Faculty of Dentistry, Tabriz University of Medical Science

Abstract

Titanium root form implants are widely accepted because of the advantages of their mechanical properties. This study compared the screw loosening between two types of implant supported crowns (cement retained and screw retained)   at the location of left lower first molar, using finite element method in a nonlinear analysis. The Dentis system was used for modeling of the implant, abutment and suprastructure. The amount of preload displacement was almost the same for both types of abutments. Applying force in any direction reduced the amount of downward preload displacement and decreased abutment-implant stability. In the cement retained crown, the amount of inner abutment displacement was always less than the screw head displacement by applying vertical, oblique and vertical-horizontal loads, so the stability of the abutment-implant complex was maintained. In the screw retained crowns under vertical-horizontal load  the amount of  displacement at  the screw  head  and  inner  side of  abutment was close  to  each other   and this put the screw on the verge of loosening.  However, under oblique pressure of 100 N, the inner abutment displacement exceeded the screw head displacement and the screw was loosened. Under vertical loading of 100 and 150 N, the stability of implant abutment was maintained. Screw loosening is less likely to occur under vertical load compared with oblique load. The cemented retained crowns have a higher biomechanical stability than screw retained crowns.

Graphical Abstract

Comparing loosening between cement retained and screw retained implant supported crowns: a dynamic non-linear finite element analysis

Keywords

Main Subjects

[1] T. Albrektsson, P.I. Branemark, H.A. Hansson, J. Lindstrom, Acta. Orthop. Scand., 1981, 52, 155-170. [crossref], [Google Scholar], [Publisher]  
[2] T.D. Taylor, J.R. Agar, T. Vogiatzi, IntJ Oral Maxillofac Implants, 2000, 15, 66–75. [crossref], [Google Scholar], [Publisher]  
[3] K.S. Hebel, R.C. Gajjar, J Prosthet  Dent., 1997, 77, 28–35. [crossref], [Google Scholar], [Publisher]  
[4] S. Sahin, M.C. Cehreli, Implant Dent., 2001, 10, 85–92. [crossref], [Google Scholar], [Publisher]  
[5] E. Torrado, C. Ercoli, M. Al Mardini, G.N. Graser, R.H. Tallents, L. Cordaro, J Prosthet Dent., 2004, 91, 532-537. [crossref], [Google Scholar], [Publisher]  
[6] W.M. Al-Omari, R. Shadid, L. Abu-Naba ́a, B. El Masoud,  J Prosthodont., 2010, 19, 263–273. [crossref], [Google Scholar], [Publisher]  
[7] P.Y. Wat, E.H. Pow, T.W. Chow, Quintessence Int., 2000, 31, 187–190. [crossref], [Google Scholar], [Publisher]  
[8] G.A. Zarb, A. Schmitt, J Prosthet Dent., 1990, 64, 185–194. [crossref], [Google Scholar], [Publisher]  
[9] S.E. Keith, B.H. Miller, R.D. Woody, F.L. Higginbottom, Int J Oral Maxillofac Implants., 1999, 14, 369–378. [crossref], [Google Scholar], [Publisher]  
[10] F. Zarone, D. Apicella, R. Sorrentino, V. Ferro, R. Aversa, A. Apicella, Dent Mater.,  2007, 23, 296–301. [crossref], [Google Scholar], [Publisher]  
[11] J.G. Wittneben, C. Millen, U. Brägger, Int J Oral Maxillofac Implants., 2014, 29, 84–98. [crossref], [Google Scholar], [Publisher]  
[12] R.E. JungA. ZembicB.E. PjeturssonM. ZwahlenDaniel S Thoma, Clin Oral Implants Res., 2012, 23, 2–21. [crossref], [Google Scholar], [Publisher]  
[13] A. Zembic, S. Kim, M. Zwahlen, J.R. Kelly, Int J Oral Maxillofac Implants., 2014, 29, 99–116. [crossref], [Google Scholar], [Publisher]  
[14] K. Wannfors, J.I. Smedberg, Clin Oral Implants Res., 1999, 10, 453–458. [crossref], [Google Scholar], [Publisher]  
[15] A.L. De Boever, K. Keersmaekers, G. Vanmaele, T. Kerschbaum, G. Theuniers,  J.A. De Boever, Journal Oral Rehabil., 2006, 33, 833–839. [crossref], [Google Scholar], [Publisher]  
[16] I. SailerS. MühlemannM. ZwahlenC.H.F. HämmerleD. Schneider, Clin Oral Implants Res., 2012, 23, 163–201. [crossref], [Google Scholar], [Publisher]  
[17] B. AssenzaA. ScaranoG. LeghissaG. CarusiU. ThamsF.S. RomanA. Piattelli, J Oral Implantol., 2005, 31, 242–246. [crossref], [Google Scholar], [Publisher]  
[18] J.P. Geng, K.B. Tan, G.R. Liu., J Prosthet Dent 2001, 85, 585-598. [crossref], [Google Scholar], [Publisher]  
[19] R.F. Wang, B. Kang, L.A. Lang, M.E. Razzoog, J Prosthet Dent., 2009, 101, 359-371. [crossref], [Google Scholar], [Publisher]  
[20] G.C. Silva, T.M. Cornacchia, C. Silami de Magalhães, A.C. Bueno, A.N. Moreira, J Prosthet Dent., 2014, 112, 1479-1488.[crossref], [Google Scholar], [Publisher]  
[21] A. Poornasrollah, R. Negahdari, V. Gharekhani, A. Torab, S. Jannati, J Dent Res Dent Clin Dent Prospect., 2019, 13, 289–297.
[22] J. Joong Ryua, P. Shrotriya, Applied Surface Science, 2013, 273, 536–541.
[23] G. Eskitascioglu, A. Usumez, M. Sevimay, E. Soykan, E. Unsal, J Prosthet Dent., 2004, 91, 144‐150. [crossref], [Google Scholar], [Publisher]
[24] A.  Balik, M. O.  Karatas, H. Keskin, J Oral Implantol., 2012, 38, 491–496.
[25] S.F. Rosenstiel, M.F. Land, Contemporary fixed prosthodontics. Elsevier Health Sciences, 2015, 318.
[26] R.L. Simon, J Prosthet Dent., 2003, 90, 517–521. [crossref], [Google Scholar], [Publisher]
[27] B. Carlson, G. Jonsson, L. Sandahl, T. Nordin, P. Hising, P. Nelvig, A.C. Branting, Int J Prosthodont.,2001, 14, 159–163. [crossref], [Google Scholar], [Publisher]
[28] I. Nergiz, P. Schmage, R. Shahin, J Prosthet Dent., 2004, 91, 513–517. [crossref], [Google Scholar], [Publisher]
[29] H.J.A. Meijer, M.E. Geertman, G.M. Raghoebar, J.M. Kwakman, J Oral Maxillofac Surg.,      2001, 59, 1260–1268. [crossref], [Google Scholar], [Publisher]
[30] C.J. Goodacre, G. Bernal, K. Rungcharassaeng, J.Y.K. Kan, J Prosthet Dent., 2003, 90, 121–132. [crossref], [Google Scholar], [Publisher]
[31] P.J. HenryW.R. LaneyT. JemtD. HarrisP.H. KroghG. PolizziG.A. ZarbI. Herrmann,  Int J Oral Maxillofac Implants, 1996, 11, 450-455.  [crossref], [Google Scholar], [Publisher]
[32] W.R. LaneyT. JemtD. HarrisP.J. HenryP.H. KroghG. PolizziG.A. ZarbI. Herrmann, Int J Oral Maxillofac Implants, 1994, 9, 49-54. [crossref], [Google Scholar], [Publisher]
[33] T. JemtW.R. LaneyD. HarrisP.J. HenryP.H. Krogh, G. PolizziG.A. ZarbI. Herrmann, Int J Oral Maxillofac Implants, 1991, 6, 29-36. [crossref], [Google Scholar], [Publisher]
[34] A. Ekfeldt, G.E. Carlsson, G. Borjesson,  Int  J Oral Maxillofac Implant, 1994, 9, 179-183. [crossref], [Google Scholar], [Publisher]
[35] T. Jemt, P. Pettersson, 1993, 21, 203-208. [crossref], [Google Scholar], [Publisher]
[37] T. Jemt, U. Lekholm, K. Grondahl, Int J Periodontics Restorative Dent, 1990, 10, 341-9. [crossref], [Google Scholar], [Publisher]
[38] S.F. Chuang, C.H. Chang, T.Y.F. Chen, J Mech Behav Biomed Mater, 2011, 4, 2138-2149. [crossref], [Google Scholar], [Publisher]
[39] J. Nissan, D. Narobai, O. Gross, O. Ghelfan, G. Chaushu, Int J Oral Maxillofac Implants, 2011, 26, 1102-1107. [crossref], [Google Scholar], [Publisher]
[40] J.P. Duncan, E. Nazarova, T. Vogiatzi, T.D. Taylor, Int J Oral Maxillofac Implants., 2003, 18, 561-565. [crossref], [Google Scholar], [Publisher]
[41] P.I. BrånemarkB.O. HanssonR. AdellU. BreineJ. LindströmO. HallénA. Ohman, Scand J Plast Reconstr Surg, 1977, 16, 1-132.  [crossref], [Google Scholar], [Publisher]
 
[42] P. Astrand, J. Ahlqvist, J. Gunne, H. Nilson, Clin Implant Dent Relat Res, 2008, 10, 207-217. [crossref], [Google Scholar], [Publisher]  
[43] S. Sherif, S.M. Susarla, J.W. Hwang, H.P. Weber, R.F. Wright, Clin Oral Investig, 2011, 15, 993-999. [crossref], [Google Scholar], [Publisher
[44] B.E. Pjetursson, D. Thoma, R. Jung, M. Zwahlen, A. Zembic, Clin Oral Implants Res., 2012, 23, 22-38. [crossref], [Google Scholar], [Publisher
[45] S. Sherif, H.K. Susarla, T. Kapos, D. Munoz, B.M. Chang, R.F. Wright, J Prosthodont.,   2014, 23, 1-9. [crossref], [Google Scholar], [Publisher]